Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition
         12.13.1.1. Removal and installation of the distributor of ignition
         12.13.1.2. Check of contacts of the breaker
         12.13.1.3. Replacement of contacts of the breaker
         12.13.1.4. Check and adjustment of a corner of the closed condition of contacts
         12.13.1.5. Gap adjustment between contacts
         12.13.1.6. Adjustment of a corner of an advancing of ignition
         12.13.1.7. Survey of a cover of the distributor
         12.13.1.8. Check of a centrifugal regulator of the distributor of ignition
         12.13.1.9. Check of the vacuum proof-reader of the distributor of ignition
         12.13.1.10. Check of the coil of ignition
         12.13.1.11. Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits



12.13.1.7. Survey of a cover of the distributor

GENERAL INFORMATION

To uncover 1 the distributor, to wipe it from a dust and to examine. The cover should be dry. The piece of coal 2 should freely, without jammings to move in a cover. Plugs of wires of a high voltage should be pure, on them there should not be corrosion or burning out traces.

Contacts from the interior of a cover also should not have corrosion and burning out traces. On a cover there should not be chips and cracks, and also breakdown traces on the distributor case. The cover is not subject to repair, and if on it there is at least one defect from listed, to replace it.