Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation

Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition Removal and installation of the distributor of ignition Check of contacts of the breaker Replacement of contacts of the breaker Check and adjustment of a corner of the closed condition of contacts Gap adjustment between contacts Adjustment of a corner of an advancing of ignition Survey of a cover of the distributor Check of a centrifugal regulator of the distributor of ignition Check of the vacuum proof-reader of the distributor of ignition Check of the coil of ignition Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits Check of contacts of the breaker

1. To disconnect wires of a high voltage from a distributor cover.
2. To remove the screen 21 (see fig. Ignition distributor).
3. To unfasten springs 11 and to uncover 1.
4. To remove a begunok 3 and the antidust screen 4.
5. To unscrew bolts 5 and to uncover 6.
6. To watch contacts while the assistant will include a starter. If between contacts occurs strong sincere, means the condenser 9 is faulty and it is necessary to replace it. Between contacts of the breaker should slip separate weak sparks.
7. To take out mobile contact 7 and to examine. If on contacts there are easy blue traces of burns, means the condenser is faulty. If traces gray or black, it is norm. In case of big transfer of metal from one contact on another to smooth out it a velvet file. After cleaning to wash out contacts by gasoline. When cleaning it is necessary to remove a hillock on motionless contact. To deduce completely a crater on mobile contact it is not recommended. Contacts should adjoin to each other all surface.
8. To establish into place removed details.