Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation

Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition Removal and installation of the distributor of ignition Check of contacts of the breaker Replacement of contacts of the breaker Check and adjustment of a corner of the closed condition of contacts Gap adjustment between contacts Adjustment of a corner of an advancing of ignition Survey of a cover of the distributor Check of a centrifugal regulator of the distributor of ignition Check of the vacuum proof-reader of the distributor of ignition Check of the coil of ignition Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits Check of spark plugs


Normal operation of engines in big degree depends on a condition of spark plugs. Having turned out candles, examine them. If the candle insulator light brown or gray-steel color, means the carburetor is adjusted correctly and the candle works correctly. Light gray or white color of an insulator specifies that a mix very poor if the deposit on a candle black, means a mix reenriched. If electrodes and an insulator of a candle are greasy, it means that or this candle gives a spark with interruptions, or piston rings are worn-out. Before installation of a candle it is necessary to clear a metal brush, to wash out gasoline and to dry. To adjust a gap between candle electrodes, turning in a lateral electrode. To bend the central electrode it is impossible, since it is possible to damage a candle. Tighten candles the moment of 20 N of m (2,0 кгс.м).