Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition
         12.13.1.1. Removal and installation of the distributor of ignition
         12.13.1.2. Check of contacts of the breaker
         12.13.1.3. Replacement of contacts of the breaker
         12.13.1.4. Check and adjustment of a corner of the closed condition of contacts
         12.13.1.5. Gap adjustment between contacts
         12.13.1.6. Adjustment of a corner of an advancing of ignition
         12.13.1.7. Survey of a cover of the distributor
         12.13.1.8. Check of a centrifugal regulator of the distributor of ignition
         12.13.1.9. Check of the vacuum proof-reader of the distributor of ignition
         12.13.1.10. Check of the coil of ignition
         12.13.1.11. Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits




12.13.1.9. Check of the vacuum proof-reader of the distributor of ignition

GENERAL INFORMATION

For exact check of the vacuum proof-reader the vacuum pump with a manometer is required. However to check, whether the vacuum proof-reader works, it is possible by means of a stroboscope:

PERFORMANCE ORDER
1. To connect to the engine a stroboscope.
2. To start the engine.
3. To direct a stroboscope lamp on adjusting labels (see subsection 12.13.1.6 item 4).
4. To increase frequency of rotation of the engine to 3000 mines-1. To remove a hose from the vacuum proof-reader 19 (see fig. The ignition distributor), thus the label on a pulley of the crankshaft or a flywheel of the engine should be displaced. To connect a hose in the vacuum proof-reader, the label должsна to return to a starting position. If the label does not move, the vacuum proof-reader means is faulty and it is necessary to replace it or the vacuum hose is not tight.