Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation

Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition
         12.13.1.1. Removal and installation of the distributor of ignition
         12.13.1.2. Check of contacts of the breaker
         12.13.1.3. Replacement of contacts of the breaker
         12.13.1.4. Check and adjustment of a corner of the closed condition of contacts
         12.13.1.5. Gap adjustment between contacts
         12.13.1.6. Adjustment of a corner of an advancing of ignition
         12.13.1.7. Survey of a cover of the distributor
         12.13.1.8. Check of a centrifugal regulator of the distributor of ignition
         12.13.1.9. Check of the vacuum proof-reader of the distributor of ignition
         12.13.1.10. Check of the coil of ignition
         12.13.1.11. Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits

12.13.1.4. Check and adjustment of a corner of the closed condition of contacts

GENERAL INFORMATION

Corner of the closed condition of contacts (UZSK) check by means of the special adaptation. UZSK should be within 47 ° ± 3 °. If it differs, it needs to be adjusted, for what it is necessary to weaken screws of fastening of motionless contact, to insert a screw-driver into a groove of motionless contact and, turning it and by that taking away or bringing motionless contact to mobile, to adjust UZSK according to the adaptation indication. To tighten screws of fastening of motionless contact. If there is no special adaptation for UZSK adjustment, it is possible to adjust a gap between contacts.