Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
- 11. Body
   11.1. Forward buffer
   11.2. Back buffer
   11.3. Overlay of the back buffer
   11.4. Radiator facing
   11.5. Front panel
   11.6. Forward wing
   11.7. Локарь
   11.8. Decorative molding
   11.9. Drains
   11.10. Decorative overlays of drains of a roof
   11.11. Door handles
   11.12. External lock of a door
   11.13. Internal lock of a door
   11.14. Adjustment of the limiter of the lock of a door
   11.15. External rear-view mirror
   11.16. Upholstery of the panel of a door
   11.17. Door glass
   11.18. Wind and lateral motionless glass
   11.19. Internal handle of a door
   + 11.20. Window regulator
   11.21. Central blocking of locks of doors
   11.22. Forward seat
   11.23. Back door
   11.24. Mechanism of management of a heater
+ 12. Electric equipment

11.8. Decorative molding

GENERAL INFORMATION

RELEASE MODELS TO 07.1987 G.

Removal of a decorative molding on release models to 07.1987 g.

1–decorative molding;

2–nylon scaffold

Removal

PERFORMANCE ORDER
1. To warm up a molding the hair dryer.
2. To remove a molding, stretching a nylon scaffold under a molding.

Installation

PERFORMANCE ORDER
1. To clean off accurately old glutinous layer from a body surface gasoline, to dry up and warm up the hair dryer to temperature 35 ° Page.
2. To warm up the hair dryer to temperature 60 ° About a new molding.
3. To remove a protective film from a molding.
4. To put exactly a molding to a surface of a body and with force it to press.

RELEASE MODELS AFTER 07.1987 G.

Decorative molding on release models after 08.1987 g.

1–decorative molding;

2–percussion cap;

3–spring latch

Removal

PERFORMANCE ORDER
To pick up a molding 1 screw-driver, having enclosed under it a piece of an insulating tape not to damage a paint and varnish covering, and to pull out spring latches 3 of a percussion cap 2.

Installation

PERFORMANCE ORDER
1. To establish a molding 1 latches 3 in percussion caps 2 on a body.
2. To hammer latches with 3 blows of a hand.