Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      - 12.13.1. Classical system of ignition
         12.13.1.1. Removal and installation of the distributor of ignition
         12.13.1.2. Check of contacts of the breaker
         12.13.1.3. Replacement of contacts of the breaker
         12.13.1.4. Check and adjustment of a corner of the closed condition of contacts
         12.13.1.5. Gap adjustment between contacts
         12.13.1.6. Adjustment of a corner of an advancing of ignition
         12.13.1.7. Survey of a cover of the distributor
         12.13.1.8. Check of a centrifugal regulator of the distributor of ignition
         12.13.1.9. Check of the vacuum proof-reader of the distributor of ignition
         12.13.1.10. Check of the coil of ignition
         12.13.1.11. Check of spark plugs
      + 12.13.2. Transistor system of ignition
   + 12.14. Electric circuits

12.13.1.8. Check of a centrifugal regulator of the distributor of ignition

GENERAL INFORMATION

Previously to check work of a centrifugal regulator, it is necessary to turn a hand a begunok 3 (see fig. The ignition distributor), overcoming resistance of springs of a centrifugal regulator. To release a begunok, it should return at once to a starting position. If it does not occur, means springs of a regulator are stretched or jam грузики a regulator.

More exact check can be made by means of a stroboscope:

PERFORMANCE ORDER
1. To connect to the engine a stroboscope.
2. To disconnect a hose from the vacuum proof-reader of the 19th distributor.
3. To start the engine and to leave to idle.
4. To direct a stroboscope lamp on adjusting labels (see subsection 12.13.1.6 item 4).
5. Increasing frequency of rotation, to watch a label on a pulley of the crankshaft or an engine flywheel. If the label is displaced at increase in frequency of rotation, the centrifugal regulator means works.