Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
- 3. Power supply system
+ 3.1. Power supply system of carburetor engines
+ 3.2. A power supply system of engines with fuel injection
- 3.3. Power supply system of diesel engines
3.3.1. Check of supply of fuel
3.3.2. Power supply system pumping
3.3.3. Fuel pump of a high pressure
3.3.4. Beginning of forcing of the fuel pump of a high pressure
3.3.5. Draft of the starting arrangement
3.3.6. Draft of supply of fuel
3.3.7. Adjustment of frequency of rotation of idling
3.3.8. Adjustment of the maximum frequency of rotation of the engine
3.3.9. Replacement of nozzles
3.3.10. Check of candles of an incandescence
3.3.11. Check of giving of a current on candles
3.3.12. Water removal from the fuel filter
3.3.13. Replacement of the fuel filter
3.3.14. Turbokompressor
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment
|
Nest of the relay of inclusion of candles of an incandescence in the block of the relay and safety locks
Glow plugs are not subject to repair, the damaged candles replace.
| PERFORMANCE ORDER |
| 1. To connect an electric sampler between a tip of a candle of the fourth cylinder and "weight". |
| 2. To turn a key in the ignition lock in the provision of heating of candles of an incandescence. The lamp of a sampler should light up. If the lamp did not light up, to check a safety lock of candles; if the safety lock is serviceable, to take out the relay of inclusion of candles in the block of the relay and safety locks. To contact of the 30th nest of the relay to connect a sampler. If the lamp lights up, the relay means is faulty and it is necessary to replace it. If the lamp does not burn, it means damage to conducting or to system of the block of the relay and safety locks. To connect a sampler to contact 86 and to turn a key in the ignition lock in the provision of heating of candles. If the lamp of a sampler burns, means connection of contact 86 with "weight" or contact 87 with a safety lock is broken, or the relay is faulty. If the lamp of a sampler does not burn, it means damage to the block of safety locks and the relay |
| 3. To remove from candles the connecting tire. |
| 4. To connect a wire from a sampler to the positive plug of the storage battery. Serially to connect a sampler to candles, the bulb of a sampler should burn. If the bulb does not burn, the candle means is faulty and it is necessary to replace it. The moment of an inhaling of candles of 30 N · m (3,0 kgfs · м). If will be found candles with the burned-out electrodes to check nozzles by means of the special equipment. |
|
|
|