Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
- 3. Power supply system
   - 3.1. Power supply system of carburetor engines
      3.1.1. Replacement of a filtering element of the air filter
      3.1.2. Removal and installation of the air filter
      3.1.3. Temperature regulator check
      3.1.4. Check of the valve of a temperature regulator
      3.1.5. Removal and installation of the fuel pump
      3.1.6. Check of pressure of forcing of the fuel pump
      3.1.7. Fuel level sensor replacement
      3.1.8. Removal and installation of a fuel tank
      3.1.9. Replacement of the fuel filter
      3.1.10. Removal and installation of the fuel tank
      3.1.11. Accelerator cable
      + 3.1.12. Carburetor
   + 3.2. A power supply system of engines with fuel injection
   + 3.3. Power supply system of diesel engines
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

3.1.8. Removal and installation of a fuel tank

PERFORMANCE ORDER
1. To disconnect a wire from the "minus" plug of the storage battery.
2. The pump to pump out fuel from a tank since the fuel tank has no drain stopper.
3. To disconnect from the sensor 16 of level of fuel a connecting block with wires and hoses 14 and 17 (see subsection 3.1.7).
4. To lift a jack a back part of the car and to establish on supports, to remove a back right wheel.
5. To unscrew bolts of the 5th fastening of a bulk pipe.
6. To establish under a fuel tank a jack. Between a jack and a tank to lay wooden laying.
7. To unscrew bolts of 3 fastenings of a fuel tank.
8. A jack to lower down a fuel tank and to extend it from under the car.
9. To establish a fuel tank upside-down. Bolts of 3 fastenings of a fuel tank to tighten the moment of 25 N · m (2,5 kgfs · м), and bolts of the 5th fastening of a bulk pipe – the moment of 10 N · m (1,0 kgfs · м).
10. If it is necessary to remove a broad tank 22, it is necessary to unscrew bolts of its fastening and to take out it from a wheel niche.