|
Volkswagen Golf ll, Jetta II1983-1992 of releaseRepair and car operation |
|
Volkswagen Golf 2 / Jett 2 + 1.1. Short technical characteristics of diesel engines + 2. Engine - 3. Power supply system - 3.1. Power supply system of carburetor engines 3.1.1. Replacement of a filtering element of the air filter 3.1.2. Removal and installation of the air filter 3.1.3. Temperature regulator check 3.1.4. Check of the valve of a temperature regulator 3.1.5. Removal and installation of the fuel pump 3.1.6. Check of pressure of forcing of the fuel pump 3.1.7. Fuel level sensor replacement 3.1.8. Removal and installation of a fuel tank 3.1.9. Replacement of the fuel filter 3.1.10. Removal and installation of the fuel tank 3.1.11. Accelerator cable + 3.1.12. Carburetor + 3.2. A power supply system of engines with fuel injection + 3.3. Power supply system of diesel engines + 4. Coupling + 5. Transmission + 6. Transmission + 7. Forward drive + 8. Steering + 9. Suspension brackets + 10. Brake system + 11. Body + 12. Electric equipment Ëóáðèêàíò öåíà - ãåëü ñìàçêà êóïèòü ïî íèçêîé öåíå www.sexfeast.ru. |
3.1.11. Accelerator cableRemoval
Establish a cable upside-down. At installation to track, that the cable was not overwound. Before installation of the air filter the cable needs to be adjusted.
Adjustment to carry out with the assistant. Completely to squeeze out an accelerator pedal. In this situation to check, whether there is a gap between the lever of a drive of a butterfly valve of the carburetor and the limiter of complete opening of a butterfly valve. The gap should be not less than 0,5 mm. Otherwise it is necessary to adjust length of a cable of an accelerator. Depending on fastening of a cable of the accelerator shown in drawing, make its adjustment. If the cover of a cable is fixed in an arm by two nuts, it is necessary to unscrew nuts, to move a cable, increasing or reducing a gap, and to tighten nuts. If on the end of a cover of a cable there is a carving plug which is screwed in an arm and законтрена by a spring washer, it is necessary to remove a washer, to adjust length of a cable, rolling or turning out the plug, and to establish a spring washer. At some carburetors it is necessary to unscrew a bolt of fastening of a cable of an accelerator on the lever of a drive of a butterfly valve, to turn the lever and to tighten a bolt. |
|