Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation

Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
- 2. Engine
   2.1. Removal and engine installation
   + 2.2. Dismantling and engine assembly
   + 2.3. System of greasing of the engine
   - 2.4. System of cooling of the engine
      2.4.1. Replacement of cooling liquid
      2.4.2. Removal and radiator installation
      2.4.3. Removal and electrofan installation
      2.4.4. Fan thermoswitch
      2.4.5. Thermostat
      2.4.6. Removal and installation of the water pump
   + 2.5. System of production of the fulfilled gases
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

2.4.4. Fan thermoswitch

Removal and installation

PERFORMANCE ORDER

1. To disconnect a wire from the "minus" plug of the accumulator.

2. To merge liquid from system of cooling of the engine.

3. To turn out a thermoswitch 5 (see fig. A radiator and the fan of system of cooling of engines in working volume of 1,1 and 1,3 l) to remove a sealing ring of a thermoswitch.

4. To check a thermoswitch. For this purpose to suspend it in a vessel with water so that the part of a thermoswitch which is screwed in a radiator, was shipped in water. To connect it through a bulb to the storage battery. To warm up water. At temperature 93–98 ° With a bulb should light up. Let's to water cool down. At temperature 88–93 ° With a bulb should go out. If the bulb does not light up and does not die away at the specified temperatures, the thermoswitch means is faulty and it is necessary to replace it.

5. To establish a thermoswitch, having replaced thus a sealing ring. To tighten a thermoswitch the moment of 25 N · m (2,5 kgfs · м).

6. To fill in liquid in system of cooling and to connect the storage battery.