Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation



Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
- 2. Engine
   2.1. Removal and engine installation
   - 2.2. Dismantling and engine assembly
      + 2.2.1. Engines in volume of 1,1 and 1,3 l
      + 2.2.2. Engines in volume of 1,6 and 1,8 l
      - 2.2.3. Diesel engine
         2.2.3.1. Camshaft drive
         2.2.3.2. Removal and installation of a head of the block of cylinders
         2.2.3.3. Dismantling of a head of the block of cylinders
         2.2.3.4. Check and repair of a head of the block and its details
         2.2.3.5. Assembly of a head of the block of cylinders
         2.2.3.6. Adjustment of gaps between cams of a cam-shaft and levers of valves
         2.2.3.7. Technical condition of hydropushers of valves
         2.2.3.8. Intermediate shaft
         2.2.3.9. Flywheel
         2.2.3.10. Epiploons of a cranked shaft
         2.2.3.11. Oil case
         2.2.3.12. Oil pump
         2.2.3.13. Shatunno-porshnevaya group
         2.2.3.14. Cranked shaft
         2.2.3.15. Check of the block of cylinders
   + 2.3. System of greasing of the engine
   + 2.4. System of cooling of the engine
   + 2.5. System of production of the fulfilled gases
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment



2.2.3.14. Cranked shaft

GENERAL INFORMATION

Order of removal, check and installation of a cranked shaft same, as at engines in working volume of 1,1 and 1,3 l (see subsection 2.2.1.13).

Different data are provided below.

Axial gap of a cranked shaft of 0,07-0,17 mm.

Limiting admissible axial gap of 0,37 mm.

Nominal diameter of a radical neck of 53,958-53,978 mm.

Admissible palpation on an average radical neck of 0,06 mm.

Admissible gap between loose leaves of radical bearings and necks of the crankshaft of 0,17 mm.

Admissible gap between loose leaves of shatunny bearings and necks of the crankshaft of 0,12 mm.

Moment of an inhaling of shatunny bolts:

 – a bolt with carving М9х1х15 – 50 N · m (5,0 kgfs · м);
 – a bolt with carving М8х1х25 – 30 N · m (3,0 kgfs · м).