Volkswagen Golf ll, Jetta II

1983-1992 of release

Repair and car operation

Volkswagen Golf 2 / Jett 2
+ 1.1. Short technical characteristics of diesel engines
+ 2. Engine
+ 3. Power supply system
+ 4. Coupling
+ 5. Transmission
+ 6. Transmission
+ 7. Forward drive
+ 8. Steering
+ 9. Suspension brackets
+ 10. Brake system
+ 11. Body
- 12. Electric equipment
   12.1. Block of safety locks and relay
   + 12.2. Generator
   + 12.3. Starter
   + 12.4. Forward headlight
   12.5. Replacement of a lamp of the forward index of turn
   12.6. Replacement of lamps of a back lamp
   12.7. Replacement of a lamp of illumination of registration plate
   + 12.8. Windscreen screen wiper
   + 12.9. Screen wiper of a door of a back
   12.10. Adjustment of a jet of washers of glasses
   12.11. Combination of devices
   12.12. Block of control lamps
   - 12.13. Ignition system
      + 12.13.1. Classical system of ignition
      - 12.13.2. Transistor system of ignition
         12.13.2.1. Removal and installation of the distributor of ignition
         12.13.2.2. Dismantling and assembly of the distributor of ignition
         12.13.2.3. Check and adjustment of a corner of an advancing of ignition
         12.13.2.4. Control unit check
         12.13.2.5. Check of the sensor of the Hall
         12.13.2.6. Check of the coil of ignition
         12.13.2.7. Precautions at work with electronic systems of ignition
   + 12.14. Electric circuits

12.13.2.3. Check and adjustment of a corner of an advancing of ignition

GENERAL INFORMATION

Combination of a label of an advancing of ignition on a flywheel with a label on a coupling case

1–a label of an advancing of ignition on a flywheel;

2–a label of VMT of the first cylinder on a flywheel;

3–a label on a coupling case

Corner of an advancing of ignition regulate on the heated-up engine with the adjusted frequency of rotation of the idling, all consumers of the electric power are switched off, the fan of system of cooling does not work.

PERFORMANCE ORDER

1. To connect a stroboscope.

2. To start the engine and to leave to idle.

3. To direct a stroboscope lamp on a window in a coupling case, previously having taken out a plastic stopper. The label 1 on a flywheel should coincide with a label 3 on a coupling case. If labels 1 and 3 do not coincide, it is necessary to weaken an inhaling of a bolt of fastening of the distributor and, turning the distributor, to achieve combination of labels 1 and 3. To tighten a bolt of fastening of the distributor.

4. To check frequency of rotation of idling.

5. Again to check installation of a corner of an advancing of ignition

6. To disconnect a stroboscope.